Forum - Topic


Edit Channels War


Forum Tech corner Edit Channels War




 maxipes  
František
2016-09-02 13:07:44

What is needed for this :

a set of needle files , abrasive discs to drill , el . drill, emery cloth , one pair of hands and a lot of patience.

 maxipes  
František
2016-09-02 13:09:26

I started to fit and polish will transition edges in the exhaust duct between the cylinder and bolted steel flange , against which their own exhaust. At intake , after removal of the tongues 3 to see the main input channels mixture into the cylinder. The edges of these channels were coarse and curly . As seen in the picture again , it was necessary to sharpen those edges counters to edge ( to get a better break in pieces flowing mixture) and polish . The same applies the finishing touches on a cylinder with overflow channels (the side where the surface of the cylinder rests on Carters ) .

 maxipes  
František
2016-09-02 13:10:51

Again, sharpen edges divides the transfer port and polish the entire space . It sounds relatively simple, but in terms of labor intensity (at least to me) took about 2.5 hrs. , 3 possible work . ATTENTION When sharpening the edges of the channel to the edge , it is necessary to proceed slowly and in small pieces, as with all such adjustments , the collected material will not be pasted back there anymore , so rather slowly and constantly monitored. Cruftiest is understandably a final polishing .

 maxipes  
František
2016-09-02 13:13:43

It is a fact that the engine was quite revived, but only in the upper speed range , ie after the opening of the throttle , and from about 9000 rev / min . Here is familiar with a relatively sharp increase in speed and the Furious vylítnou the red line.Jak I mentioned earlier, SIKLA would this still adjusting to lower his head ( and thus increase the compression ratio ) . Yet that moment I thought about it and basically I would be costless (father I would not work arranged ) , I finally repudiated this idea in order to longer engine life .

 maxipes  
František
2016-09-02 13:15:09

So that's it.


Reply