Forum - Topic


vyměnit náhon rychloměru


Forum General talking vyměnit náhon rychloměru




2016-10-15 01:55:11

nahrazovat náhon rychloměru Jawa 634. Jak odstranit konec z motoru?

maxipes  
František
2016-10-15 07:41:25

I do not understand what the problem was on the pinion. VIZ. FOTO.

maxipes  
František
2016-10-15 07:48:22

Unscrews at the tachometer to the engine

2016-10-15 08:13:57

I wish to install new cable. I do not understand how to disconnect at engine

maxipes  
František
2016-10-18 12:27:59

cslamuseum: Removing the speedometer. After removing the left cover, clutch and primary chain Unlock the drive by pushing the insurance circles.

Take off the pad and the drive wheel with a rubber sealing ring, which is in the housing in front of the drive wheel,

we go from the left part of the cabinet.

maxipes  
František
2016-10-18 12:31:00

cslamuseum: We take care of us when breaking damage tooth wheel drive ratio. Before stopping, we make sure that it is removing the screws securing the flexible shaft at the bottom of the left part of the cabinet. If he had not screwed, we destroyed when breaking the rubber sealing ring. Dismantling rubber O-rings and ball bearings part of the crankcase.

maxipes  
František
2016-10-18 12:35:08

cslamuseum: Rubber gaskets (seals, Simmering) are removed from the crankcase part, only if it is absolutely necessary, because when removing mostly damaged and must be replaced. Therefore they exchanged only if leaking. Leakage is often caused by hardening

(Zestárnutím materials) damage the seal portion during assembly or dirt, further dropping or vysmeknutím compression spring or normal service wear.

maxipes  
František
2016-10-18 12:38:08

cslamuseum: The sealing ring under dynamo in the right half crankcase is somewhat different. When detaching unscrew three

fixing screws and remove the "complete sealing" in the form of a circular cap and a paper gasket underneath. Custom rubber sealing ring is pressed into said cap. Usually we exchange a part of the whole, supplied by the manufacturer,as well as paper gasket.

maxipes  
František
2016-10-18 12:40:23

cslamuseum: Unless the engine apart and are not separated casing parts, levering damaged sealing ring with engine 250 and 350 screwdriver. After the withdrawal of all components that are before him. If the engine is disassembled, it can be after having removed the bearing rings under go free damage, and that the pipe corresponding to the external diameter of the sealing ring.

maxipes  
František
2016-10-18 12:42:41

cslamuseum: Sealing rings drive ratio newer version can be pulled out from the outer side of the hook, whereby, however, the O-ring breaking down. For engine Jawa-CZ 350 can go without damaging the ring from inside the chassis when the lid Scans left and dismantled all relevant components.

maxipes  
František
2016-10-18 12:44:26

cslamuseum: When pushing new rings, we must take care to avoid damaging the ring on the edge of the hole for mounting screw drive ratio. In case of frequent replacement, e.g. in the shop, produce a simple insert is shaped so that, after insertion

the hole for the clamping screw is flush with the opening for the sealing ring.

maxipes  
František
2016-10-18 12:57:09

cslamuseum: Will it be enough.

maxipes  
František
2016-10-18 13:08:30

I probably would not have written better in English SNAT it would be understandable


Reply